KIT# 52285-1
03/17/09
KS
23. On each side, remove the rubber plug in the side of the frame rail (Fig.BB).
24. Position the rear mounting plate against the side of the frame rail so the two upper mounting points fall through the
opening in the front of the core support. Place a ½" lock washer over a ½" x 1½" bolt, and place a ¼" x 1" x 2" backing
plate with wire through the opening in the front of the frame rail. Thread the ½" x 1½" bolt into the backing plate (Fig.CC).
25. Trim the air deflector on each side using the red lines
in Figure DD as a guide.
26. Place the bumper core and main receiver brace over
the ends of the frame rails. On each side, replace the top
10mm (head) bumper core bolt, and tighten (Fig.EE —
driver's side).
27. Bolt the main receiver brace to the rear brace using
½" x 1½" bolts, lock washers and nuts (Fig.FF).
Fig.CC
Fig.DD
Fig.EE
Fig.FF
MOUNTING BRACKET KIT
INSTALLATION INSTRUCTIONS
ROADMASTER, Inc. 6110 NE 127th Ave. Vancouver, WA 98682 1-800-669-9690 fax 360-735-9300 www.roadmasterinc.com
Fig.BB
All illustrations and specifications contained herein are based on the latest information available at the time of publication approval.
ROADMASTER, INC. reserves the right to make changes at any time without notice in material, specification and models or to discontinue models.
