KIT# 52285-1
03/17/09
KS
All illustrations and specifications contained herein are based on the latest information available at the time of publication approval.
ROADMASTER, INC. reserves the right to make changes at any time without notice in material, specification and models or to discontinue models.
6. On each side, remove one T25 Torx plastic fastener and a plastic push fastener located on the inside edge of the
door jamb (Fig.H).
Note:
the T25 Torx plastic fastener is located at the top, and the push fastener is in the middle.
7. On each side, pull out and up on the plastic cover at the top corner of the fascia to remove it (Fig.I).
8. Remove the T25 and T27 Torx bolts located behind the cover (Fig.J).
Note:
the T27 Torx bolt is the one toward the
rear of the vehicle.
9. On each side, remove two plastic push fasteners attaching the rear of the lower rocker panel cover to the rear fender
liner (Fig.K).
10. On each side, pull out on the bottom and the rear of
the rocker panel cover and slide it back to unclip it (Fig.L).
Note
: if the car is on a lift, it must be lowered to the ground
before the rocker panel covers can be removed.
Fig.H
Fig.I
Fig.J
Fig.K
Fig.L
MOUNTING BRACKET KIT
INSTALLATION INSTRUCTIONS
ROADMASTER, Inc. 6110 NE 127th Ave. Vancouver, WA 98682 1-800-669-9690 fax 360-735-9300 www.roadmasterinc.com
