KIT# 52285-1
03/17/09
KS
All illustrations and specifications contained herein are based on the latest information available at the time of publication approval.
ROADMASTER, INC. reserves the right to make changes at any time without notice in material, specification and models or to discontinue models.
BOLT TORQUE REQUIREMENTS
METRIC BOLTS
Thread Size
Grade
Plated / Unplated
12mm-1.25 ........8.8 ............70 ft./lb. 65 ft./lb.
12mm-1.5 ..........8.8 ............66 ft./lb. 61 ft./lb.
12mm-1.75 ........8.8 ...........65 ft./lb. 60 ft./lb.
14mm-2.0 ..........8.8 .........104 ft./lb. 97 ft./lb.
METRIC BOLTS
Thread Size
Grade
Plated / Unplated
8mm-1.0 ............8.8 ............20 ft./lb. 18 ft./lb.
8mm-1.25 .........8.8 ............19 ft./lb. 18 ft./lb.
10mm-1.25 ........8.8 ...........38 ft./lb. 36 ft./lb.
10mm-1.5 ..........8.8 ...........37 ft./lb. 35 ft./lb.
STANDARD BOLTS
Thread Size
Grade
Torque
5/16..................... 5 ........................... 13 ft./lb.
3/8....................... 5 ........................... 23 ft./lb.
7/16..................... 5 ........................... 37 ft./lb.
1/2....................... 5 ........................... 56 ft./lb.
5/8....................... 5 ......................... 150 ft./lb.
Note: The torque values represented below are intended as general guidelines. Torque requirements for specific applications may vary. Roadmaster does not warrant
this information to be accurate for all applications and disclaims all liability for any claims or damages which may result from its use.
34. Trim the grille using the red lines in Figure KK as a reference. Reinstall the trimmed grille (Fig.LL).
35. Reinstall the fascia, wheels, air bag and the air bag sensors by reversing steps 1 through 17.
Note:
to replace the
rocker panel covers, unscrew the plastic fittings from the rocker panel and slide them into the mounting points on the
rocker panel cover. Set the rocker panel cover in place, aligning the plastic fasteners over the studs, and lock each cover
into place (Fig.MM).
Fig.NN
Fig.MM
MOUNTING BRACKET KIT
INSTALLATION INSTRUCTIONS
ROADMASTER, Inc. 6110 NE 127th Ave. Vancouver, WA 98682 1-800-669-9690 fax 360-735-9300 www.roadmasterinc.com
Fig.LL
Fig.KK
36. Torque all bolts to the bolt torque requirements found at the end of these instructions.
37. Insert the removable front bracket arms into the front receiver braces, and twist each one 90 degrees to lock.
38. Attach the 10" safety cables with the cable connectors (Q-Links) to the front of the receiver braces (Fig.NN).
39. Attach the ends of the safety cables to the tow vehicle's safety cables.
40. Install the tow bar to the mounting bracket according to the manufacturer's instructions.
