KIT# 52285-1
03/17/09
KS
20. Place a 1" x 2" pipe spacer inside the bumper core (Fig.X). Bolt through the main receiver brace, bumper core
support and the pipe spacer using a ½" x 5" bolt.
Place the center brace over the ½" x 5" bolt. Place the 3/8" beveled spacer over it and bolt it into place using a ½"
lock washer and nut. Bolt the center brace to the main receiver brace using four 3/8" x 1¼" bolts, lock washers and nuts.
Repeat for the other side of the vehicle.
Note:
rotate the beveled spacer so the lock washer sits flat against it (Fig.Y).
Tighten all bolts to the bolt torque requirements found at the end of this document.
21. On each side, temporarily remove a piece of tape
covering the opening in the end of the frame rail (Fig.Z).
22. On each side, pull back the fender liner and secure
it with wire to gain access to the side of the frame rail (Fig.
AA).
Fig.X
Fig.Y
Fig.AA
Fig.Z
q
All illustrations and specifications contained herein are based on the latest information available at the time of publication approval.
ROADMASTER, INC. reserves the right to make changes at any time without notice in material, specification and models or to discontinue models.
q
center brace
remove this tape
MOUNTING BRACKET KIT
INSTALLATION INSTRUCTIONS
ROADMASTER, Inc. 6110 NE 127th Ave. Vancouver, WA 98682 1-800-669-9690 fax 360-735-9300 www.roadmasterinc.com
Fig.W
