KIT# 52285-1
03/17/09
KS
28. Working on the driver's side only, and using the lower pre-existing hole in the rear brace as a template, drill a ½"
hole through both sides of the frame rail. Use the upper pre-existing hole in the rear brace as a template and drill a ½"
hole through the outside of the frame rail only (Fig.GG).
29. Place a ½" x 4½" bolt through the rear brace, frame rail and a ¼" x 2" x 2" backing plate. Finish with a ½" lock
washer and nut (Fig.HH). Repeat steps 28 and 29 for the passenger side.
30. Remove four ½" x 1½" bolts attaching the main receiver brace to the rear brace. Remove the upper 10mm (head)
bolt attaching the bumper core to the frame rail.
31. Place a ¼" x 1" x 2" backing plate in the frame rail. Bolt through the upper rear mounting point on the rear brace
using a ½" x 1½" bolt and ½" lock washer (Fig.II).
32. Break the wire off the backing plates using a pair of pliers (Fig.JJ).
33. Reinstall the bumper core and replace the bolts attaching the main receiver brace to the rear braces.
Note:
replacing
the bumper core bolts requires a universal extension. Tighten all bolts to the bolt torque requirements found at the end of
this document.
All illustrations and specifications contained herein are based on the latest information available at the time of publication approval.
ROADMASTER, INC. reserves the right to make changes at any time without notice in material, specification and models or to discontinue models.
Fig.HH
Fig.II
Fig.JJ
MOUNTING BRACKET KIT
INSTALLATION INSTRUCTIONS
ROADMASTER, Inc. 6110 NE 127th Ave. Vancouver, WA 98682 1-800-669-9690 fax 360-735-9300 www.roadmasterinc.com
Fig.GG
