RMG TERZ 94, Руководство по эксплуатации

Страница: 29 / 66

Operation
Operating Instructions for the TERZ 94 Electronic Turbine Meter
27
Principle of programming
For programming, you must always proceed as follows:
•
First change over to the display value to be modified.
−
To do this, press either the control button (only forwards)
−
or the internal buttons “ + ” and “-” or the external buttons “
∧
” and “
∨
”
(forwards and backwards).
•
Change to programming mode by pressing “ P ” for at least 2 seconds . On
the left side of the display, a flashing character or cursor will appear.
If necessary press the “
|
→
” key so many times until a flashing character
appears.
0 1 2 3.2 3 P/m3
•
You can now modify the flashing decimal by pressing either “ + ” or “
∧
” (+1)
or “-” or “
∨
” (-1).
Example: If you press the “
∧
“ button three times, the first decimal will be
increased from 0 to 3. If an “L” appears on the far left side of the display,
this value is a list. With a list, you can only scroll in the specified values.
•
After you have completed your programming of the first decimal, press
“
|
→
” once and the next character will start to flash.
Now proceed with your programming until you have reached the last
decimal place.
•
Then you must press “
|
→
” once again to have the set value accepted and
quit programming mode.
•
Press the “P“ button to set the decimal point behind the flashing digit.
With totalizers, modes and integers, no decimal point is permitted.
•
Press the control button if you have made an error or if you want to
discontinue inputting data.
Flashing character