Hold two profiles together at ridge using
one B-4 connector. Secure with two bolts.
8.4A
8.4B
8.4C
From inside, fit one F-1 profile with two set
screws facing inside next to panel. Hold in
place with one B-4 connector on right side.
Secure with two bolts. Repeat to install F-1
profile on opposite side.
From inside, fit one F-1 profile with
three set screws next to panel. Position
profile so set screws face inside and
middle set screw is closer to top. Fit
other end into B-4 connector and
secure with one bolt. Repeat to install
F-1 profile on opposite side.
8.5A
8.5B
8.5C
Return to back right to install section three and
remove bungee cord nearest to back. Remove
plastic film from both sides of one W-1 panel.
With side marked “ UV Resistant” facing
outside, install the next panel on the right
at the back. Push panel into roof ridge
channel until the other end rests on
gutter ledge and then slide towards
F-1 profile at back.
Hold two profiles together in place at ridge
using one B-4 connector. Line up center hole
with long hex bolt in roof ridge. Place washer on
long bolt and secure all screws with three bolts.
*
NOTE: W-2 panels are installed in step 8.8
35 of 46
WWW.RSIWW.COM
NOTE: VIEWS FROM OUTSIDE.
NOTE: VIEWS FROM OUTSIDE.
B-4
S-5B
1
S-2C
3
1
Connector
QTY
S-2C
2
Connector
QTY
W-1
1
Panel
QTY
24” x 57”
R-1
F-1
F-1
B-4
B-4
S-2C
6
3
Connector
QTY
W-1
2
Panel
QTY
24” x 57”
W-1
W-1
NOTE: VIEWS FROM INSIDE.
NOTE: VIEWS FROM INSIDE.
NOTE: VIEWS FROM INSIDE.
NOTE: VIEWS FROM INSIDE.
Continue working from front right corner. Remove plastic
film from both sides of one W-1 panel. With side
marked “ UV Resistant” facing outside, fit top
end of panel into channel in roof ridge near
corner. Push panel into roof ridge channel
until the other end rests on gutter
ledge and then slide towards F-7
corner profile. Repeat to install
W-1 panel in front left corner.
B-4
F-1
F-1
B-4
F-1
F-1
F-1
R-1
B-4
