Assemble Front Wall and Gable
5.1
The door frame is 65¼” high from the base. To avoid adjusting the placement after assembly,
prepare door frame using the exact measurements listed in these steps.
B-2
S-2C
4
2
Connector
QTY
Connector
QTY
S-2A
S-2B
16
16
Fit B-2 connector onto profile and position so bottom
of connector measures 8” from bottom of profile.
Secure each with two bolts.
Prepare two F-3 profiles.
Slide three set screws
into bolt track and
position as shown.
QTY
Profile
2
F-3
F-1
F-6
2
2
56”
15
⅞”
Prepare two F-6 profiles. Slide set screws into both bolt tracks on mitered end of profile and
one bolt track on the other end. The single set screw will sit on the inside when installed. Hand
tighten each set screw to hold in place.
F-6
F-6
5.2A
5.2B
5.1A
5.1B
Prepare two F-1 wall profiles. Slide set screws into same bolt track, one on each end of profile.
Position profile so set screw near base is on the inside when installed. Hand tighten each set
screw to hold in place.
F-1
F-1
23”
F-3
F-3
8”
(203mm)
8”
(203mm)
F-3
F-3
B-3
B-3
WARNING: The cut edge of F-3 profile is
sharp. Use extreme caution when handling.
WWW.RSIWW.COM
21 of 46
NOTE: Have the hex shaped indent facing up. Screw in until it is flush with bottom of nut so
it slides easily into bolt tracks. After inserting into bolt track, screw in until it holds in place.
Make certain the pieces are in the correct positions before assembling.
Carefully follow the order of assembly to ensure an easy installation.
Wear proper safety gear including work shoes, gloves and goggles.
Prepare needed set screws as shown in step 1.1A
