WWW.RSIWW.COM
38 of 46
Remove next bungee cord and continue working from
back to install section five. Remove plastic film
from both sides of one W-1 panel. With side
marked “ UV Resistant” facing outside,
install the next panel on the right at the
back. Push panel into roof ridge channel
until the other end rests on gutter
ledge and then slide towards
F-1 profile at back.
8.7A
NOTE: VIEW FROM OUTSIDE.
8.7G
B-4
S-5B
2
S-2C
6
2
Connector
QTY
B-4
S-2C
6
3
Connector
QTY
S-2C
4
Connector
QTY
W-1
5
Panel
QTY
24” x 57”
From inside, fit one F-1 profile with two
set screws facing inside next to panel.
Hold in place with one B-4 connector on
right side. Secure with two bolts. Repeat
to install F-1 profile on opposite side.
8.7E
NOTE: VIEWS FROM INSIDE.
Remove final bungee cord and repeat steps 8.7D through 8.7F to
install next two W-1 panels and F-1 profiles.
NOTE: VIEW FROM OUTSIDE.
Remove plastic film from both sides of one W-1
panel. With side marked “ UV Resistant” facing
outside, install the next panel on the right
at the back. Push panel into roof ridge
channel until the other end rests on
gutter ledge and then slide towards
F-1 profile at back. Repeat to
install W-1 panel on left.
8.7D
8.7B
8.7C
Hold two profiles together in place
at ridge using one B-4 connector.
Line up center hole with long hex
bolt in roof ridge. Place washer on
long bolt and secure all screws with
three bolts.
NOTE: VIEWS FROM INSIDE.
From inside, fit one F-1 profile with three set screws next to panel. Position
profile so set screws face inside and middle set screw is closer to top. Fit other
end into B-4 connector and secure with one bolt. Repeat to install F-1 profile on
opposite side.
Hold two profiles together at ridge using one
B-4 connector. Secure with two bolts.
8.7F
NOTE: VIEWS FROM INSIDE.
B-4
F-1
F-1
B-4
F-1
R-1
F-1
F-1
B-4
F-1
F-1
R-1
B-4
