5.3A
5.3B
5.3C
5.3D
5.3E
5.3F
5.3G
Fit B-3 connector and secure with two S-2C bolts.
Continue working from inside left corner, place F-6 profile with mitered end next to corner and
angled edge facing up onto corner W-1 panel. F-6 profile fits
snugly between F-7 corner profile and F-1 wall profiles.
From inside, line up F-3 profile as
shown. Make sure B-2 connector is
pointing towards door opening.
Adjust set screws and place B-2
connector on profiles as shown.
Slide set screws in vertical openings
to center of opening so B-6 trim
plate will fit properly.
Install B-6 trim plate and secure with three bolts.
Place 23 inch spacer on base next to F-7 corner profile. Fit panel into
channel in F-1 profile and slide F-1 profile against spacer to ensure
proper placement.
IMPORTANT: The panels expand and contract depending on the temperature.
To ensure proper placement, use the 23 inch spacer included with the tools.
NOTE: Panels will not fit completely to end of channels.
There will be some space to allow for temperature changes.
Working from inside front left corner, remove plastic film from both sides
of one W-1 panel. Fit panel into channel in base and corner profile,
placing side marked “ UV Resistant” facing outside.
W-1
F-7
F-1
F-6
G-1
F-7
F-6
F-3
F-1
B-2
NOTE: VIEW FROM INSIDE.
NOTE: VIEWS FROM INSIDE.
NOTE: VIEWS FROM INSIDE.
NOTE: VIEWS FROM INSIDE.
NOTE: VIEWS FROM INSIDE.
B-6
1
Trim Plate
QTY
Connector
QTY
B-2
1
S-2C
3
B-3
S-2C
2
1
Connector
QTY
W-1
1
Panel
QTY
24” x 57”
W-1
W-1
F-7
F-1
spacer tool
F-1
B-3
B-2
B-6
22 of 46
WWW.RSIWW.COM
