Riverbed SteelHead 5080, Руководство по установке и настройке

Страница: 62 / 94

62 | SteelHead GX 10000 Appliance Specifications
This table summarizes the front panel LEDs and buttons.
Label Control panel descriptions Description
1 USB port
2 NMI Button Puts the appliance in a halt state and issues a non-maskable interrupt
(NMI). This helps when performing diagnostics for a given issue where a
memory download is necessary to determine the cause of the problem.
To prevent an inadvertent system halt, the NMI button is located behind
the front Control Panel faceplate and is only accessible with the use of a
small tipped tool such as a pin or paper clip.
3 Primary Network Interface
Card (NIC) activity LED Solid green = Network link is detected.
Blinks green = Activity. The blink rate is consistent with the amount of
network activity.
4 System Cold Reset Button Reboots the appliance.
5 Hardware Status LED Off = System is powered off.
Solid green = Hardware is working correctly.
Blinks green= System hardware is degraded.
The system is operating in a degraded state although still functional, or
system is operating in a redundant state but with an impending failure
warning.
Note: The Hardware Status LED does not detect software issues, such as
licensing status or the system becoming unresponsive. Only hardware
status is shown.
Blinks amber = The system is operating in a degraded state with an
impending failure warning.
Solid amber = The system has failed or shutdown.
6 Power Button with
Integrated LED Green = System on
No light = System off
7 Drive Activity Blinks green = Activity
8 Auxiliary NIC activity LED Solid green = Network link is detected.
Blinks green = Activity. The blink rate is consistent with the amount of
network activity.
9 System ID Button with
Integrated LED Toggles the integrated ID LED and the blue server board ID LED on and
off. The System ID LED identifies the system for maintenance when
installed in a rack of similar server systems. You can also remotely turn on
and turn off the System ID LED using the IPMI “Chassis Identify”
command which causes the LED to blink for 15 seconds.
LEDs on Disk Drives Activity LED
Blinks green = Read/write activity
Disk Fault LED
Orange = Failed disk
Blinks Orange = RAID rebuild