Wheel diameter measuring gauge, IDK-BT
IDK-BT [Revision 2.2] 4
th
September 2017
5
7.
Design
7.1. Electronic gauge
The gages with bases of 200, 250 and 300 mm are shown on the Figure 1, the
gage with base of 122 mm
– on Figure 1.1. Electronic gauge contains two ball supports
to place the gauge onto the roll surface, two side magnet supports to base the gauge to
the wheel edge and a measuring tip.
There are a digital numeric display and control buttons on the front panel of the
gauge. “Charge” connector for charging device connection and Bluetooth indication LED
are situated on the top panel of the gauge.
Figure 1
Figure 1.1
7.2. Indication device (option)
PDA is designed for control of the laser scanning module, data reception from
the scanning module, indication of measurement results, parameter input and data stor-
age.
