28
RIELLOTECH CLIMA TOP - CLIMA COMFORT
RIELLOTECH CLIMA TOP - CLIMA COMFORT
Information
i
Press the information button (6) to display:
− Errors or maintenance codes (see the section "Error/
maintenance codes”)
− Special messages
Other screens:
9
Other displays depend on the system configuration and
operational status. Some of the display lines shown below
may not therefore appear.
− Room temperature
− Room temperature minimum
− Room temperature maximum
− Room setpoint 1
− Room setpoint 2
− Room setpoint 3
− Cascade flow temperature
− Boiler temperature
− Outdoor temperature
− Outside temperature min
− Outside temperature max
− DHW temp 1
− DHW temp 2
− Temperature buffer 1
− Temperature buffer 2
− Buffer tank temperature setpoint
− Flow temperature 1
− Flow temperature setpoint 1
− Flow temperature 2
− Flow temperature setpoint 2
− Flow temperature 3
− Flow temperature setpoint 3
− Collector temp 1
− Wood fuelled boiler temperature
− Solar flow temperature
− Solar return temp
− 24 hours solar energy yield
− Total solar energy yield
− Swimming pool temp
− Swimming pool setpoint
− State of heating circuit 1
− State of heating circuit 2 (not active)
− State of heating circuit
− Cooling circuit state
− State of DHW
− State of boiler
− State of solar
− State solid fuel boiler
− State buffer storage tank
− State swimming pool
− Sensor error message
− Maintenance message
− Floor curing function
− Date and time of day
− Telephone customer service
Manual mode
m
When you select manual mode, the "
h
" symbol appears and
relays are energised/de-energised not according to any heating
program but according to a default manual setting that can be
set by pressing the information button (6).
12 11 6
Boiler temperature
Chimney sweep mode selection
p
To select chimney sweep mode, press the chimney sweep but-
ton (11) briefly (max. 3 seconds). The "
h
" symbol appears. Chim-
ney sweep mode prepares the boiler for combustion analysis.
To exit chimney sweep mode, press the button (11) again. The
system exits chimney sweep mode automatically after 1 hour.
Safety thermostat test
p
To test the safety thermostat, press and hold the chimney sweep
button (11) for longer than 3 seconds.
Hold the button down for the duration of the test.
The test terminates as soon as you release the button.
9
This test must only be performed by the Technical Assistance
Service
R
, since it raises boiler temperature over the nor-
mal permitted limits.
RESET function
The meters and parameter table RESET icon only appears in the
bottom line of the display if it is possible to perform a reset in
the current user level (End user, Commissioning, Heating engi-
neer).
9
This operation must only be performed by the
R
’s Tech-
nical Assistance Service.
Press "
K
" (13) when the "
Yes
" prompt flashes on the display.
13
Temperatura caldaia
