21
INStAllAtION
Positioning on floor
1
Fastening screw M4
2
Anti-vibration element (supplied)
3
Spirit level
1
2
3
—
screw the unit to the ground
—
tighten using a torque wrench
—
apply a tightening torque of 3.5 Nm
Provide for lifting of the unit from the floor:
130
9
If the device is installed in an area that is subject to heavy
snowfalls, place the unit in a raised position so as to pre-
vent the air flow from being blocked or install a roofing to
protect it.
9
Adequate anti-freeze systems should be used for installa-
tions in extremely cold areas, where there is a possibility of
freezing.
9
While operating in heating mode, the unit generates con-
densate, which will deposit on the support surface if there is
not discharge. This could freeze if the outdoor temperatures
are below zero, thus creating a hazard. In this case, appro-
priate barriers should be installed in order to prevent people
from approaching the unit.
1
Lifting from the top
2
Condensate discharge connector
1
2
Model
1070
M
1100
M
1125
M
1125
t
1140
t
Refrigeration characteristics
Condensate discharge
attachment Ø
mm
16
4 x 17
Hanging position
9
Properly sized supporting brackets must be used if the devi-
ce is installed in suspension.
9
Ensure that the wall section does not include bearing ele-
ments, pipes or electric lines.
1
Supporting brackets
2
Anti-vibration element (supplied)
3
Fastening screw M4
1
2
3
Содержание 20153499
Страница 29: ...29 Installation MODEL 1100 M ...
Страница 31: ...31 Installation MODEL 1125 T 1140 T ...
Страница 42: ......
Страница 43: ......