Riello 20127839, Инструкции по установке и техническому обслуживанию

Страница: 11 / 28

11
INStAllAtION
— drill holes in the marked positions
— fix the metallic support with the screws and the wall plugs
9
Check that the installation is horizontal using a water level.
Drilling into the wall:
A Inner side
B Outer side
1 Hole protective insert, supplied
2 Plastic tube
5 - 6 mm
A
1
2
B
— drill the through hole into the wall
— keep a downward inclination toward the external side
— insert a plastic tube in the hole in order to protect the con-
nections
— introduce the supplied hole protection insert on the inter-
nal side of the wall
— seal with stucco
9
In case of connections on the rear side of the unit, refer to
chapter "Refrigerating connection"
p. 12 for the position
of the hole.
leak test:
The unit is supplied as pre-charged with nitrogen.
1 Liquid pipe
2 Gas pipe
3 Gas connection plug
4 Pressure presence indicator
5 Fluid connection plug
1
2
3
4
5
— ensure that pressure presence indicator is protruding
— partially loosen one fitting plug
— check for nitrogen leaks to verify that there is pressure in-
side the device
9
If pressure indicator is not protruding, do not continue in-
stallation and check for leakage inside the unit.
9
Contact
R
Technical Support Service.
Device preparation:
1 Pipe locking bracket
2 Motor-driven deflector locking insert
2
1
— remove the motor-driven deflector locking inserts
—
lift the pipe locking bracket
Assembly:
— fasten the unit to the upper part of the metallic support
— check that the unit is correctly hooked by moving it to the
left and to the right
— place the unit in the middle of the metallic support
To ease the connections:
1 Pipe locking bracket
2 Packaging polystyrene protection
1 2