Ricoh G091, Руководство по обслуживанию

Страница: 73 / 298

SERVICE CALL CONDITIONS
SM 4-1 G112/G113/G116/G094/G095/G091
Trouble-
shooting
4. TROUBLESHOOTING
4.1 SERVICE CALL CONDITIONS
NOTE: SC codes that are not the same for all models are shown in the left side
margin. If no model-specific identifier is present in the left side margin,
assume that code applies to all models.
4.1.1 SUMMARY
There are 2 levels of service call conditions.
Level Definition Reset Procedure
A
Only a service representative can reset
this SC. This will prevent damage to the
machine.
The machine cannot be used. Enter engine SP mode 5810
and press “#”. When ‘execute’
is displayed, press “#” again.
Then press ‘Escape’. Then
turn the main power off/on.
B
The SC can be reset by turning the
operation switch off and on (if the SC was
caused by a sensor error). Switch the main power off and
on.
NOTE: 1) If the problem is with electrical circuit boards,disconnect the connectors
first. Then reconnect the connectors before you replace the PCBs.
2) If the problem is with a motor lock, first examine the mechanical load.
Then replace motors or sensors.
CÓPIA NÃO CONTROLADA
CÓPIA NÃO CONTROLADA