Ricoh FAX7000L, Руководство по обслуживанию на месте

Страница: 126 / 377

SCU Bit Switch 21 - Continued
BIT FUNCTION
DATA COMMENTS
5 Dedicated tx 0: Disabled When this is 1, an extra option (for programming dedicated tx
parameter program- 1: Enabled
parameters - see page 2-43) appears in the display for
ming
programming Quick and Speed Dial (Functions 51, 52, 56,
and 57). After programming, reset this bit to 0.
6
Memory read/write 0: Enabled
When this is 0, a remote control system can read or write
1: Disabled
RAM data, such as TTl, RTI, and bit switches. The remote con-
trol system must know the RAM addresses of this machine to
make any changes. If the remote control device can only
enter four-digit RAM addresses, then only addresses 240000
to 24FFFF can be changed; for example, to change address
240000, the control system operator must enter 0000.
When this bit is 1, all remote control systems are locked out.
7
Recognition of the
0: Unlimited length as-
remote terminal’s
sumed
paper length 1: Limit specified by the
other end is recognized.
0: The unit always assumes that the other end has no rx
paper length limit (such as in a thermal roll machine), and ig-
nores the paper length limit in the protocol from the other end.
1: Use this setting if the machine frequently sends to
machines that use cut paper. For example, if the receiver
specifies Letter size in the protocol, but the machine is send-
ing a Legal size page, the machine will send MPS when it has
sent a Letter sized length of data. The other end will then feed
another sheet of copy paper and the rest of the data will be
sent.
2-74