Ricoh FAX7000L, Руководство по обслуживанию на месте

Страница: 127 / 377

SCU Bit Switch 22
BIT FUNCTION DATA
COMMENTS
0 Inch-mm conver- 0: Disabled The data is scanned in dot per inch format to meet Group 4
sion in tx mode 1: Enabled standards. This bit determines whether to convert the data
into dot per mm format for transmission to a Group 3 terminal.
If this bit is 0, the data is not converted and the printed copy
at the other end is slightly distorted (if the other end is a
Group 3 based machine). If this bit is 1, the data will be con-
verted; however, the conversion cuts out dots and lines of
data, so the copy quality may be poor. The recommended set-
ting for this bit is 0.
1 Inch-mm conver- 0: Disabled The printer is designed to operate in dot per inch format, and
sion in rx mode 1: Enabled assumes that each received page is in a dot per inch layout.
This is to meet Group 4 standards. However, Group 3 mes-
sages are in dot per mm format, so they are slightly distorted
when they are printed (if the other end is a Group 3 based
machine). This bit determines whether to convert the data
from a dot per inch format into a dot per mm format before
printing. If this bit is 0, the data is not converted and the prin-
tout is a slightly distorted representation of the original. If the
bit is 1, the data is converted; however, as dots and lines of
data are inserted, the copy may not be a faithful reconstruc-
tion of the original.
2 Not used Do not change the factory settings.
to
7
2-75