Ricoh DD 5450, Руководство по обслуживанию на месте, Страница: 353 / 403

351
８
Chapter 8 HELP Mode Function and Operation Procedures
Page 1:
● Adjustment.
MASTER CLAMP MARGIN
M-MAKE SPEED MAGNIFICATION
M-MAKE FEED VOLUME MAGNIFICATION
1.
● Operation procedure
(1) Master Feed Adjustment
(2 pages in total)
HELP-046
Call the HELP mode “H-046”.
2.
Adjust the master feed.
3.
Adjustment
1. Select and touch the item to be adjusted.
Master clamp margin
● Make adjustment so that the master edge is seen
from the check hole of the master clamp. The
master clamp margin becomes shorter by "-" and
longer by "+".
Return to the HELP mode.
HELP-046
2. Enter the value by the NUMERIC keys or change the value
by the PRINT POSITION
keys.
● Press the HOME key to invert "+"and "-"of
the selected set value.
● Press the C (clear) key to return the selected set
value to the value before change.
3. Press the
X
=
key to store the set value.
● Adjust so that the vertical length of the two
100 mm squares made up in the HELP-30 test
pattern is 200±0.5 mm.
● Press the MASTER MAKING key to feed the master
to the master edge sensor. The master is cut into
the length of 200 mm. Adjust the master make
horizontal feed volume magnification so that the cut
master length is 200±0.5 mm.
M-Make speed magnification
M-Make feed volume magnification
+0.0
− 0.5
+0.3
MASTER CLAMP MARGIN(mm)
M-MAKE SPEED MAGNIFICATION(%)
M-MAKE FEED VOLUME MAGNIFICATION(%)
1.
2.
3.
+0.0
− 0.5
+0.3
1.
2.
3.
HELP-046
+0.0
− 0.5
+0.3
1.
2.
3.
Press the STOP key. The HELP mode selection display will reappear.
Enter “ 046 ” by the NUMERIC keys and then press the
PRINT key.
→
To exit the HELP mode : Turn the power switch OFF.
→
To access another HELP mode : Enter the desired mode number
using the numeric keys.
MASTER CLAMP MARGIN(mm)
M-MAKE SPEED MAGNIFICATION(%)
M-MAKE FEED VOLUME MAGNIFICATION(%)
MASTER CLAMP MARGIN(mm)
M-MAKE SPEED MAGNIFICATION(%)
M-MAKE FEED VOLUME MAGNIFICATION(%)
3