Ricoh DD 5450, Руководство по обслуживанию на месте, Страница: 234 / 403

５
232
Chapter 5 Master making / Master Feed / Ejection Section
(3) Adjusting the B / C Mode
Adjustment procedure
1. Remove the drum from the machine body.
2. Access HELP mode H-012.
3. Press and hold down the " PRINT POSITION"
key to move the master clamp opening/closing lever
toward C mode position wiser than B mode position.
4. Turn the power off, then on again.
The master clamp opening/closing lever will move
into the B mode-position and stop.
5. Turn off the power, and install the drum to the
machine body.
6. Open the master ejection box. Then press the
paper eject switch (drum rotator switch) to set
the master clamp position in front of the open/
close lever.
● When drum is removed from main body( B mode )
● C mode
C mode adjustment must be carried out After
B mode adjustment has been completed.
Before adjustment
IMPORTANT:
HELP-012 → See page 319
1. Adjustment for B mode
7
Shift
6 S t o p i n
front of lever
● Do not touch the drum or rolls when
operating the paper eject switch.
● Do not put your hands or fingers inside
the machine during operation. They
could be caught up or crushed in the
machinery,resulting in injury.
WARNING
7. Rotate the drum paying attention to the clearance of
the master clamp opening/closing lever.
2