Ricoh DD 5450, Руководство по обслуживанию на месте, Страница: 229 / 403

227
５
Chapter 5 Scanner Section
(2) Attaching the Front Wire
Place on pulley
Secure with nut
Place on pulley
Place on corner
guide
Place on
spring
Wrap 6 times
Wrap 4 times
● For removal of the Scanner unit
● For removal of the front wire
Adjustment procedure
1. Insert the ball end of the wire into the groove opening on
the pulley. Wrap the wire four times in the rear, and 6 times
on the operation side.
2. Place the wire on the screw side onto the pulley.
3. Place the wire on the front pulley of Slider B.
4. Pass the screw through the bracket opening, and secure
it in place with two nuts. (Temporarily secure the bracket
and the screw tip with a gap of 10 mm.)
5. Place the wire on the hook side on the pulley.
6. Place the wire on the pulley in rear of Slider B.
7. Place the wire on the corner guide.
8. Place the spring on the hook.
9. Adjust the securing position in 4 so that the total spring
length is approx. 40 mm.
Ball end
Spring length40mm
Place on pulley
Place on pulley
Temporarily secure at 10 mm
bracket and screw tip
7
1
2
3
5
8
6
4
1
→ See page 186
→ See page 191
REFERENCE: