Ricoh D093, Руководство по обслуживанию

Страница: 763 / 779

Printer, Scanner SP Tables
SM Appendix 2-241 D093/D094
Appe
ndix:
SP
Mode
Ta
b
le
s
006 Bit Switch 6 Settings DFU
007 Bit Switch 7 Settings DFU - -
008 Bit Switch 8 Settings
DFU
009 bit 0 PDL Auto Detection of Jobs Submitted via USB/IEEE1284
To be used if PDL auto detection fails. A failure of PDL auto detection does
not necessarily mean that the job cannot be printed. This bit switch tells
the device whether to execute a time out immediately (default) upon
failure or to wait 10 sec.
bit 1 Forced Printing
If enabled, the image will be printed regardless of whether the specified
roller for the correct size paper or not. This is similar to "Form Feed" on a
standard printer. Default: Enabled
bit 2 Job Cancel
If enabled, all jobs will be cancelled after a jam occurs.
Note: If this bit switch is enabled, printing under the following conditions
could cause problems:
ƒ Job submission via USB port or parallel port.
ƒ Spool printing: WIM> Configuration> Device Settings> System
bit 3 DFU
bit 4
Bit 4 determines the timing of the PJL USTATUS JOB END sent when
multiple collated copies are being printed.
0 (default) : JOB END is sent by the device to the client after the first copy has
completed printing. This causes the page counter to be incremented after the
first copy and then again at the end of the job.
1: JOB END is sent by the device to the client after the last copy has finished
printing. This causes the page counter to be incremented at the end of each
job.
bit 5 - 7 DFU
⇒
Rev. 06/01/2011