¾
Orient a Tan Interface Block with the oval hole forward (as shown in figure
C) toward the front of the HD punch and the round hole toward the rear of
machine over the two available holes. Make sure the counter bores in the
blocks face outward. See counter bore example in Figure D). Note the nine
other mounting holes will face up.
Fig. C
Oval Hole Forward On Block
Fig D
Counter Bore Example
¾
Attach the rear Allen screws first; use the provided longer screws to
attach the block securely to both sides of the machine symmetrically as
shown in Figure B and C.
4) Mounting the APES-14 to an HD punch.
¾
Check your HD-7000 or HD-6500 for front cover warping. Warping occurs over
time and must be corrected before proceeding. See Figure E-1.
Fig E-1
If your machine has any warping, open the machine top cover while referring to
Section 3). Take a pair of pliers and gently bend down the warped tabs back flush to the
machine front. Replace the cover and safety screw again referring to Section 3).
Page 5
Issue “A1” 09/03 PDI Part # 900600 www.RHIN-O-TUFF.com
