1) Important Safety Notice!
Make sure you read this section very carefully! Learn to recognize this Safety
Alert Symbol. The APES-14 & Manual punch has been designed to provide a
very high level of protection to an operator. Follow the guidelines below while
installing, operating and maintaining your machine.
¾
Always replace fuses or circuit breakers with the correct amperage
and type.
¾
If the machine cycles erratically, call dealer immediately for service.
¾
Never bypass Safety devices.
¾
Turn both power switches off before removing a die or performing
maintenance.
2) Placing the APES-14 in the proper location:
Locate a clear work area 48” wide X 30” deep with a duplex outlet within 5 feet that
provides a 15-amp service (16-amp European) which is protected at the customer’s
circuit box. The work area must be a solid and firm cabinet or a heavy duty table with a
flat level surface. Never attempt to move the HD punch with one person! Always
move your HD punch with two people, one on each side. Locate your HD-7000 or
HD-6500 on the right side of a 48” wide work area with the chip tray near the front edge
of the work area. It is recommended that you use the large chip drawer (P.D.I. P/N
071820) in your HD-7000 or HD-6500 with the APES-14 for larger chip capacity.
Page 3
Issue “A1” 09/03 PDI Part # 900600 www.RHIN-O-TUFF.com
