Remove the Bracket Assembly by loosening the two thumb screws located
one on each end of the assembly as shown and shift assembly left so that the
Assembly falls clear of the Ejector. After removing the assembly, re-tighten
the screws.
6. Ready to Operate the APES-14.
Now that you have setup both the APES-14 Reception and Ejector you’re
ready to begin a job.
Fig. AA
Place your job on top of the Ejector just behind the punching location. Locate
the edge to be punched toward the front of the machine and face up. Position
your Foot Pedal in a comfortable location.
Begin loading the APES-14 Ejector by picking 20-25 sheets and setting them
in the APES-14 Ejector down inside the HD punch die, and jogging the pages
down and right against the Paper Stop(s). As you actuate the foot pedal begin
reaching for another 20-25 sheets to feed into the Ejector. Repeat.
You will find the APES-14 has increased your productivity by doing the take-
away and stacking of your job for you.
Page 16
Issue “A1” 09/03 PDI Part # 900600 www.RHIN-O-TUFF.com
