RGB Omicrom FT, Руководство по обслуживанию

Страница: 8 / 116

OMICROM FT
SERVICE MANUAL
21 September 1998
2.1
2. SERVICE INFORMATION
This chapter include several sections where different type of information for
servicing the Omicrom FT monitors is included.
2.1. Monitor and accessories cleaning.
The
Omicrom FT
monitor and accessories must be kept clean on a routine basis,
in accordance to the instructions provided here. To clean the monitor or their
accessories it is necessary to disconnect the monitor from the AC Power and the
different accessories from the monitor. After cleaning of the different parts of the
equipment , always allow them dry thoroughly before use.
The outside of the monitor may be wiped clean with a cloth slightly dampened with
mild detergent or normal hospital bactericides. Liquid must not be poured inside
the equipment. It must not be cleaned with isopropyl alcohol or other dissolvents.
Do not use abrasive agents. Avoid liquid entering inside the NIBP connector.
As a general rule, do not immerse the different cables and probes into water or
any other liquid. Besides, the continued flexing of cables and wires during the use
of the monitor or during the cleaning procedure could break the internal wires
and, as a consequence, produce the failure of the monitor.
A very important aspect that must be considered is the cleaning procedure of the
cuffs and hoses supplied with the unit. Care must be taken not to immerse these
elements in any kind of liquid to avoid that the liquid enters them at any time. If
this happens accidentally, then it may be dried by passing air through the cuff.
The cuff can be cleaned by hand washing in warm soapy water.
Both the ECG cable and the electrode leads may be cleaned and disinfected by
wiping with a 10% solution of household bleach or any other similar commercial
product. Do not use alcohol, since it will attack the protective plastic cover of the
cables causing them to undergo a premature erosion.
For the cleaning of sensors or cables, hold the sensor in one hand at the tip and
wipe the sensor and cable towards the plug end. If excessive pressure is used,
the covering will be stratched, which may break the internal wires and destroy the
probe.
Do not boil or autoclave the monitor, the sensor or the cables, because it can be
destroyed.