RGB Omicrom FT, Руководство по обслуживанию

Страница: 47 / 116

OMICROM FT
SERVICE MANUAL
21 September 1998
4.10
b) Disconnect the AC/DC-Line
Filter cable (2) and remove the
two nuts (3) with its washers.
Remove the board, bringing it
out from the plastic hook
spacer (4).
Assembly:
Replace the two spacers in the
screws of the chassis (in the
right side of the chassis - 3 -).
Place the AC/DC Board
making sure that the plastic
hook spacers (4)tighten well.
4.9. Supply Board (P000PLAC05 Internal Code)
a) Disconnect the cables that comes from the Connector Board
(P000CABL03 and P000CABL04 Internal Codes).
b) Unscrew from the board the five screws that are fastening it to the
metallic chassis and take the board out. It is mandatory to use nylon screws
for the two upper screws.
Assembly:
Replace two plastic hook spacers on the Supply Board in the two foreseen
holes for this matter.
4.10. Connector Board (P000PLAC07 Internal Code)
a) Remove the four nuts from
the board subjection to the
metallic chassis. Remove also
the two nuts (placed outside of
the metallic chassis) of the
Sup-D-9 connector. Take out
the board.
Assembly:
Replace the spacers in the
four screws that are in the
metallic chassis basis.
Replace in the chassis hole
the metallic cover of the Sub-D
9 connector.