RGB Omicrom FT, Руководство по обслуживанию

Страница: 16 / 116

OMICROM FT
SERVICE MANUAL
21 September 1998
2.9
2.3. Verification routines.
In this section it is explained the verification procedures that must be followed to
ensure that the Omicrom FT monitor is performing well.
Any failure detected during the tests must be located and repaired. After this
repairment, the monitor must be checked again completely before using it.
2.3.1. Daily verification routine.
Daily or each time the monitor is used, the operator must review the next points:
1. To inspect the monitor and the accessories and, if signs of damaged are
detected, replace or not use the damaged items.
2. To clean the monitor and their accessories according the instructions
given in section 2.1.
3. To inspect the AC power cord and, if signs of damage are detected,
replace it with an original RGB part replacement.
4. To check the battery status. Power up the monitor from its internal
battery and check the level of charge at the indicator placed at the
bottom right part of the display. If the charge level is too low or if the
‘Battery’ LED is flashing, connect the monitor to the mains supply and
switch on the rear panel mains power switch. Leave the monitor
charging until the charge level reaches the maximum.
5. To check the monitor operation. The basic points to check are: graphical
presentation by the display, adjustment of the parameters measured,
selection of the configuration options and adjustment of patient alarm
levels for each parameter. After checking these points, return all
adjustments to the desired settings.
If any failure is detected during this daily verification, contact with qualified
technical personnel authorized by RGB MEDICAL DEVICES for servicing the
monitors.
2.3.2. Periodical verification routine.
This sections describes the verification routine that must be performed each six
months by a qualified technician. Previously it must be done the daily verification
routine describe at the previous section.
In order to carry out this verification, it is necessary to use the next auxiliary
equipments:
•
BioTek Simulator Model LionHeart 3 or equivalent.
•
Pressure manometer.
In this section it is described the verification associated with each signal. Only it is
necessary to carry out those verifications, according the Omicrom FT model (so
each model monitors several signals). To verify each signal only it is necessary to
activate the signal at the monitor.