C O M M U N I C A T I O N S S E T U P
Ethernet Control
350-9047 v3.0.1
DGy Model 201x User’s Guide
135
. . . . .
IP ADDRESS SETUP
. . . . . . . . .
VIA SERIAL PORT
Use the following steps to change the
DGy 201x
IP address using the
serial port:
1.
Connect
DGy 201x
as outlined in the
Installation
section in
Chapter 2 and set up the Hyperterminal as described in the
Serial Communications
section on page 131 of this chapter.
2.
In the Hyperterminal window, type:
IPADDR
... and press
ENTER
.
DGy 201x
responds with the current IP address. Make a note of
the address before proceeding with the next step.
3.
Type
IPADDR
followed by a space, and the new IP address (as
provided to by the network administrator).
S
Example
: If the new IP address is
192.168.1.190
, type:
IPADDR 192.168.1.190
... and press
ENTER
.
4.
DGy 201x
responds with the following message:
The system must be restarted for your changes to
take effect. Do you want to restart the system
(y/n)?
~
Press
y
to restart
DGy 201x
and use the newly
assigned IP address.
~
Press
n
to retain the current IP address, and discard the
new address.
5.
After the
DGy 201x
restarts, confirm the new setting by typing
the command
IPADDR
. If the
DGy 201x
has accepted the
command, it responds with the new IP address just entered.
Once IP address has been set, connect the PC to the
DGy 201x
using
Ethernet. In Chapter 2, refer to the
DGy Applications Suite
section for
instructions.