RGB Spectrum DGy 201x, Руководство пользователя, Страница: 105 / 158

C O M M A N D L I N E I N T E R F A C E
Commands
350-9047 v3.0.1 DGy Model 201x User’s Guide 95
. . . . .
T i M ing LIST [<1..160> [<1..160>]] |
[ACTIVE] Displays the list of saved input and output timings.
If two numeric arguments are supplied, displays all
entries in the range. ACTIVE, displays only the
active timings.
T i M ing LISTCLEAR (none) Deletes all user entries from the Timing List.
T i M ing LISTLOAD <100 ...160> <name>
<hfp> <hs> <hbp>
<hact> <vfp> <vs>
<vbp> <vact> <hfreq>
<sync> <hpol> <vpol>
<il> This command is used to create and save a user
timing set to the Timing List.
User defined entries may be saved to the list using
slots 100 - 160. Timing slots 1 - 99 are reserved for
factory defined timing settings.
The name parameter is a name that is used to
identify the timing set (for example
mytiming3 ).
hfp - width of the horizontal front porch (pixels)
hs - width of the horizontal sync pulse (pixels)
hbp - width of horizontal back porch (pixels)
hact - width of the active picture area (pixels)
vfp - width of the vertical front porch (pixels)
vs - width of the vertical sync pulse (pixels)
vbp - width of vertical back porch (pixels)
vact - height of the active picture area (pixels)
hfreq - horizontal frequency (Hz)
sync - type of sync signal (analog 3, 4 or 5 wire)
hpol - polarity of horizontal sync pulse (0=negative,
1=positive)
vpol - polarity of vertical sync pulse (0= negative,
1=positive)
il - interlace (0 = non interlace, 1 = interlace)
Table 6-2 Input Commands (Continued)
Command Arguments Description