30
connection is always life and providing an audio stream via USB to the
connected device. It can be user determined, in which case the user can
determine the status of the USB line through the dialer. If USB calls only is
selected, the USB connection can only be active when a USB call is detected.
This requires the communication application to send according signals on the
USB interface, indicating the call state. USB audio can only be activated for a
USB call.
Advanced Audio Settings will be described further down in this section.
In the Date/Time submenu NTP servers providing network time can be
specified. The menu also allows specifying the time zone in which it is being
used. Finally, the format in which dates and times should be presented in the
dialer can be selected.
Note:
Daylight savings time rules that might be used in the location where
the phone is being installed can be set using the web interface.
The Web Access check box allows enabling / disabling the web access to the
phone.
Enabling Recent Calls allows storing data on the recent calls made to or from
the phone. Disabling “Recent Calls” displays a popup asking “Do you want to
clear the recent call list?”
If “Yes” is selected, all call data stored on the device will be deleted.
If “No” is selected, the call data of previous calls will be saved, but no
new call data is added, and the call data cannot be accessed until Recent
Calls is re-enabled.
The Idle LED Color setting allows specifying the LED state when the system is
idle and USB audio is disabled.
Reboot reboots the device.
Reset Data allows resetting of factory defaults and removing usage data, either
for the whole system, or by area.
And finally, the admin user can select to log out of the interface.
Advanced Audio Settings
