GB
GB
INDICE
27
2. FUNCTIONING
4- The cursor above the number 1 (which represents the Monday) will
flash. Select the number corresponding to the day of the week using
or
. Save by pressing
OK
5 - To exit the setting the time and day mode, press
mode
3 times.
2.9.2 Choices programmes
Schematic sequence of programmes:
Your device’s default setting is non-stop Comfort for 7 days a week.
- Comfort: your device will operate in Comfort mode, 24 hours a day, as
regards each day selected.
Note: You can set the Comfort mode temperature to the temperature
you require (see Setting the comfort mode temperature see paragraph
2.6.
- Eco: The device will operate 24 hours a day in Eco mode.
Note: You can set the temperature-lowering parameters (see Setting
the Eco mode temperature lowering-level see paragraph 3.2).
- Pl: your device will operate in Comfort mode from 06:00 to 22:00 (and
in Eco mode from 22:00 to 06:00).
- P2: your device will operate in Comfort mode from 06:00 to 09:00 and
from 16:00 to 22:00 (and in Eco mode from 09:00 to 16:00 and from
22:00 to 06:00).
- P3:your device will operate in Comfort mode from 06:00 to 08:00,
from 12:00 to 14:00 and from 18:00 to 23:00 (and in Eco mode from
23:00
to 06:00, from 08:00 to 12:00 and from 14:00 to 18:00).
To proceed with programming, perform the following steps:
1 - From the Automatic, Comfort, Eco or Antifreeze modes, press
mode
for 5 seconds.
2 - Press again
mode
so that the cursor moves to
prog.
The days of the week will scroll on the display together with the associated
programs (default Comfort - CONF).
4 - Chose the programme you want for this day with
or
.
5 - Press
OK
to save and go to the next day, or in the case of P1, P2 and P3, if
the programmed time interval is not suitable for your needs, you can change the
individual programs.
WARNING!
By changing the expected intervals for P1, P2 or P3 programs,
the variations will be transmitted to all the days of the week for which such pro-
grams will be configured.
To change the intervals, press and hold
OK
for 5 seconds to change P1, P2,
P3 as follows (example for P1):
5 - Start time P1 (default set at 06:00) will start to flash.
You can change the time in increments of 30 minutes by pressing
or
.
3 - Press
or
The programme set for day 1 (1= Monday, 2 = Tuesday, etc.) will flash.
