Retsch ZM 300, Руководство пользователя

Страница: 73 / 93

Installing additional equipment
73
9.2 Cyclone separator with collecting receptacle
For larger quantities of sample material, the cyclone separator allows material discharge of up
to 4500 ml in the collection receptacle.
During the grinding process, air throughput occurs. This transports the sample material into the
collection receptacle of the cyclone separator. The air throughput depends on the mesh size of
the ring sieve, the rotor speed and the air routing.
9.2.1 Installing the cyclone separator with collecting receptacle
For installation, also observe the assembly instructions for additional equipment.
Install the cyclone separator with collection receptacle as follows:
Fig. 47: Device with cassette and grinding tools
1. Switch on the device.
2. Open the device hood (2).
3. Switch off the device while the device hood
(2) is open.
➔
The device is switched off and the device
hood (2) is open ( Fig. 47 ).
4. If inserted, remove the grinding tools and
cassette (26) from the interior (10) (
Fig. 47
).
5. Pull out the rubber sleeve (9), which is the
opening for the cyclone cassette (26),
upwards (
Fig. 47
).
Fig. 48: Device with through cassette and support
6. Push in the through sleeve for the cyclone
(9.1).
7. Set the support on the side of the device
and secure it to the base plate of the
device with the three screws provided (
Fig.
48
).
➔
The support is installed.
8. Place the through cassette (26.1) at the
position of the standard cassette (26) ( Fig.
48 ).
9. Insert the grinding tools (see "Inserting the
grinding tools and cassette") ( Fig. 48 ).
10. Close the through cassette (26.1) with the
lid ( Fig. 48 ).
11. Switch on the devices.
12. Close the device hood (2).
2
26.1
9.1
10