Retsch Mixer Mill MM 500 nano, Руководство пользователя

Страница: 67 / 95

Device control
67
7.9.3 Save a Programme
Proceed as follows to save the configured parameters in a program preset:

Press to save the configured parameters in the selected program preset.
7.9.4 Delete a Programme

To delete all parameters of a programme, tap on the button (S1.2).

Confirm the deletion by tapping on the button (S2.2).

Abort with the button (N2.2).
7.10 Cycle mode
Press the button in the Main menu to switch to the Cycle program mode. After switching on
the mill, the display changes to Cycle program 1; otherwise to the last cycle program which has
been used.
In the Cycle program mode, cycle programs can be selected, edited, saved, deleted and
started.
If sample materials are frequently ground with the same parameters, these parameters can be
stored in cycle program memory locations and called up as Standard Operating Procedures
(SOP), whenever required.
Up to four memory locations are available for cycle programs.
The following parameters can be stored in the individual cycle programs:
•
Vibration frequency
•
Grinding time
•
Cycles (repetitions of grinding time and vibration frequency)
A cycle comprises of two parameter sets (A and B). The vibration frequency
and the grinding time
can be freely selected for each parameter set. The complete cycle program consists of the two
parameter sets (A and B) and the selected repetitions.

When starting grinding via a cycle program, the parameters of the grinding cannot be
changed during the grinding process.