Respironics bilichek, Руководство по обслуживанию

Страница: 13 / 36

BiliChek Service Manual
13
1014988
NOTE: When Deep Discharging the battery pack, the BSI
will blink amber during the discharge cycle, become constant
amber when recharging, and then green when fully charge.
NOTE: IF the BSI is flashing red when the battery pack is in
place, try resetting the battery pack in the charging well. If the
problem persists, try another battery pack. If the problem
continues, the charger base has malfunctioned and needs
service.
8.0 Initial Set-Up
♦
Visually inspect that all components are without
physical damage.
♦
Plug the power cord into the power supply and then
into a grounded outlet.
♦
Connect the power supply to the charger base by
inserting the plug into the socket on the rear of the
charger base. The Battery Status Indicator (BSI) lights
will flash red, green, amber, and then off (approxi
mately 1 second each) to indicate proper operation.
♦
To install the battery pack, insert the bottom of the
battery pack into the bottom of the Bili Chek
hand held unit and then rotate battery and snap it into
place.
♦ To remove the battery pack press the release latch at
the top of the battery pack and rotate it out of the
Bili Chek hand-held unit.
Before the initial use, both battery packs should be fully
charged. After installing one of the battery packs into the
Bili Chek hand-held unit, insert the hand-held unit into the
charger base well “A”, as shown on page 12 of this manual.
The indicator light will glow amber to indicate that the battery
pack is being charged (consult section 11.2 Troubleshooting
Flow Chart of this manual if the indicator is blinking red or
not illuminated). Now insert the auxiliary battery pack into
well “B” as shown on page 12 of this manual. The BSI will
glow amber to indicate that it is charging. Charge both battery
packs fully until green lights are displayed on both BISs
(page 12)