ResMed HumidAire 3i, Руководство пользователя

Страница: 12 / 157

7
S
TARTING AND
S
TOPPING
T
REATMENT
E
NG
LI
SH
2 Remove the water chamber (E-3) and carefully fill it with fresh, clean water (E-4) . Make
sure you keep the level of the water under the maximum water level mark
(E-4a)
.
Always ensure that the water chamber is clean. See “Cleaning and Maintenance” on
page 10.
!
WARNING
Do not overfill the water chamber, as water may enter your flow generator and air
tubing.
!
CAUTION
Do not use any additives (eg scented oils and perfumes). They may reduce the
humidification output of the HumidAire 3i and/or cause deterioration of the water
chamber materials.
3
Carefully place the filled water chamber into the humidifier docking station
(E-5)
and
latch the cover (E-6) .
The H
UMID
A
IRE
3i is now ready for use.
S
TARTING AND
S
TOPPING
T
REATMENT
S
TARTING YOUR
T
REATMENT
Please refer to the illustration in section
F
of the illustration sheet.
1
When your H
UMID
A
IRE
3i is attached and the flow generator is powered, the
indicator light lights up on the H
UMID
A
IRE
3i . A prompt for the Warm-Up feature
(not available on all models) may appear.
When activated, this feature allows the water to warm up before you start treatment.
2 If the Warm-Up feature is available, use it to pre-heat the water before starting your
treatment. Skip this step if you wish to start treatment immediately.
W
ARM
-U
P
F
EATURE
(
NOT AVAILABLE IN ALL MODELS
)
Note : Check your flow generator user’s manual to see if this feature is available.
To start the Warm-Up feature:
i. Select
Warmup
by pressing the Right key on the control panel.
The following message is displayed for 2 seconds:
ii. After 2 seconds the WARMING screen is displayed.
RAMP: 10min
menu
warmup
HUMIDIFIER
WARMING
WARMING
menu exit
338284r3.book Page 7 Tuesday, November 14, 2006 1:23 PM