Renova turborex TSP 180, Руководство по эксплуатации

Страница: 14 / 33

14
maintenance instructions
Our TX - TX HD brakes require periodic maintenance as they have parts subject to wear. In order to avoid
problems on the brake and to corrupt its operation, below you will find the checks to be carried out on our
brakes and the replacement procedures if something should be changed.
maintenance
• Check when the systems are switched on or in any case on a daily basis that the
suction and pressure fans are working correctly. Operation of the brake without
sufficient ventilation can lead to excessive overheating which seriously damages
brake linings, fans and other components.
• Check the wear indicator on the side casing every month. If
the indicator is positioned in the yellow area, check the state
of the linings and if some are more worn than others, swap their position. If the
indicator is positioned in the red area it is necessary to replace them.
• Check every 3 months that the pistons are not full of dust
or dirt. Clean the sliding surface with compressed air. Check
that the pistons slide freely. If not, spread a thin film of
lubricating, water-repellent, anti-adhesive silicone grease
specific for metal-rubber, the internal surfaces of the
cylinder and the guide. Also check the good condition of the
lip seals. If not, replace them.
• Check every 3 months that there are no lumps of dirt between the toothing of the
hub and the discs that could obstruct their free sliding. If not, clean them with a
wire brush
.
ATTENTION:
Before working on the brake, always disconnect the power supply to the fans. The
moving blades can be dangerous for the operator's fingers.