48
To copy an album:
• Switch to CD mode. If playback starts automatically, press the button (9) to stop playback.
• Use the
ALBUM/PRESET
(10) or
ALBUM/PRESET
(11) button to select the album that you want to copy.
• Press the
REC./DEL.
button (18). "REC" will appear on the LCD display. Wait for a few seconds until the system
has finished reading the USB memory stick and "ONE" is displayed.
• Use the
TUNING/SKIP
wheel (8) to select "DIR", and then press the
REC./DEL
. button (18) again. The copy
process will start after a few seconds.
• Press the (9) or
REC./DEL.
button (18) to stop copying the album.
•
"END REC“ will be displayed when the files have been copied.
10. Using the remote control
a) Inserting/changing the remote control battery
The remote control battery is protected from discharge by an isolation film. Remove this film before use by
pulling it out of the remote control's battery compartment.
• Change the battery when the turntable stops responding to the remote control (and you are sure that the infrared
sensor (17) is clean and that there are no obstacles impeding reception).
Follow the steps below to change the battery:
• Press the latch on the battery holder (see diagram on the remote control) and remove it from the back of the remote
control in the direction of the arrow.
• Remove the used battery (if applicable).
• Insert a 3 V CR2025 battery into the battery compartment. Ensure that you pay attention to the polarity markings
(plus/+ and minus/-). Refer to the diagram on the back of the remote control.
• Slide the battery holder back into the compartment in the opposite direction of the arrow.