Section 3 On-Board Programming
Rev. 2.00 Dec 13, 2004 page 75 of 82
REJ05B0520-0200
(8) Setting up for writing user data
Figure 3.21 shows an example of a dialog box for write commands for extracting addresses
0xF000 to 0xF0FF from the user data to transfer to 0x10000 to 0x100FF only. In this example,
application program TEST.MOT is written to flash memory.
For details of writing in boot mode, see section 3.2, Writing in Boot Mode. Here, the write address
for the write/erase contorl program is changed to address H'10000 in flash memory. Set the
address as a 32-bit hexadecimal value.
Calculation example: H'F000 + offset = H'000010000
Offset = H'00010000 to H'0000F000 = H'00001000
Figure 3.21 Example Write Command Dialog Box
(a) Before transferring the user data to the F-ZTAT microcomputer, check whether to erase the
pertinent block in flash memory. (This is necessary only in user program mode.)
(b) If erasing flash memory, erase the pertinent block in flash memory, then transfer the user data.
Содержание F-ZTAT H8S/2132F
