Section 2 F-ZTAT Microcomputer On-Board Programming Tool
Rev. 2.00 Dec 13, 2004 page 34 of 82
REJ05B0520-0200
Table 2.8
On-board Programming Software Transfer Process
Name of Transfer process
Control
•
Auto bit-rate matching
•
In boot mode, sets the transfer rate between the
host machine and F-ZTAT microcomputer
(continuous transmission of H'00)
•
Write control program transfer
•
Transfers the write control program to the internal
RAM of the F-ZTAT microcomputer (binary data)
•
Erase target block starting address
transfer
•
Transfers the starting addresses of the blocks to be
erased so that block areas in flash memory can be
erased (binary data)
•
Application
program
transfer
•
Transfers the application program to be written to
flash memory (binary data).
Start of transfer process
Start of transfer process
End of writing
(a) Transfer of starting addresses
of blocks to be erased
(b) Application program transfer
(a) Auto bit rate matching
(b) Write control program transfer
(c) Application program transfer
End of writing
(1) Transfer Process in Boot Mode
(2) Transfer Process in User
Program Mode
Figure 2.14 On-Board Programming Software Transfers in Boot Mode
and User Program Mode
Содержание F-ZTAT H8S/2132F
