Renesas F-ZTAT H8S/2132F, Руководство пользователя

Страница: 82 / 95

Section 3 On-Board Programming
Rev. 2.00 Dec 13, 2004 page 72 of 82
REJ05B0520-0200
(4) Setting the adapter board mode setting switch
Set the adapter board mode setting switch to user program mode. User program mode is selected
by setting switches (1) and (2) in figure 2.3 to the settings shown in table 3.2.
Table 3.2 Settings for User Program Mode
Enable/Disable Switch 0/1 Switch
Switch
No. Control
Signal
Enable Setting Disable Setting 0 Setting 1 Setting
1 FWE/FWP Enabled Disabled Low High
2 MD0 Enabled Disabled Low High
3 MD1 Enabled Disabled Low High
4 I/O0 Enabled Disabled Low High
5 I/O1 Enabled Disabled Low High
6 I/O2 Enabled Disabled Low High
Switch position
(side view)
E
D
E
D
0
1 1
0
Note: With the above settings, the settings of switches 2 to 6 (0/1 switches) are Don’t care.
See table 2.4 for other F-ZTAT microcomputer settings.
(5) Setting up for user program mode
Set the switches shown in table 2.10, then press the START/STOP switch on the adapter board
((1) in figure 3.11). The START LED lights and user program mode starts.