Renesas F-ZTAT H8S/2132F, Руководство пользователя

Страница: 71 / 95

Section 3 On-Board Programming
Rev. 2.00 Dec 13, 2004 page 61 of 82
REJ05B0520-0200
(3) Setting the Adapter Board Mode Setting Switch
Set the adapter board mode setting switch to boot mode. Boot mode is selected by setting the
enable/disable switch (1) and the 0/1 switch (2) shown in figure 2.3 to the settings shown in table
3.1.
Table 3.1 Settings for Boot Mode
Enable/Disable Switch 0/1 Switch
Switch
No. Control
Signal
Setting Setting 0 Setting 1 Setting
1 FWE/FWP Enabled Disabled Low High
2 MD0 Enabled Disabled Low High
3 MD1 Enabled Disabled Low High
4 I/O0 Enabled Disabled Low High
5 I/O1 Enabled Disabled Low High
6 I/O2 Enabled Disabled Low High
Switch position
(side view)
E
D
E
D
0
1 1
0
(4) Power Supply
Turn on the user system. Next, if you are supplying external power to the adapter board, turn on
the POWER switch on the adapter board. When power is supplied to the adapter board, the
POWER LED (green) lights on the adapter board (see (8) in figure 2.2).
Note: With the above settings, the settings of the 0/1 switches 2, 4, 5, and 6 are Don’t care.
Connect the MD2 pin of the H8/3067F to the MD1 pin of the adapter board.
Other settings for the F-ZTAT microcomputer are as shown in table 2.4.