REMA TLM77 RMH/100, Руководство пользователя

Страница: 9 / 31

9
objects
brace plate
objects
5.4.3 Operators should be very careful to use different jacks to lift a heavy-duty weight. Pay
attention to the shifting of center of gravity during lowering or lifting the weight. The
total lifting capacity of all jacks should be larger than load of lifted weights.
5.4.4 The owner of jack should guarantee all of the stick labels concerning safety standards
keeping on its relative locations, which should be replaced when they can not be
read clearly.
5.4.5 This operation manual can not cover all situations, please follow each step of it
cautiously.
6. Maintaining
6.1 Routine inspection
6.1.1 Before operation, please inspect and confirm that:
(1) All of the stoppers and screws of jack have been screwed up tightly.
(2) There is no oil leaking on the jack's pump.
(3) There is no cracking or deformation on pump body, tooth plate and its base.
(4) The pump should be operated normally without load.
6.1.1.1 Under the frequent use of the jack, the time of checking shall be shortened as well,
and the following checking points shall be emphasized:
(1) All of the jack stoppers, screws, and nuts should be screwed up sufficiently and should
be adjusted when it is necessary.
a)
When the jack is in loading state, please pump it totally until the release valve
opening and without any oil-leaking (but the oil spot on the surface of pillar or valve stem is in
normal). Please release the pressure of pump and check the pillar to confirm the pillar being
flat and vertical without any shocking and scraping. If any damage of it being found the
pillar should be changed in time.
(2)
When the jack is reducing, operator should check whether the reducing movement is
stable or not and it should be wedged (but some slight vibration is in normal).
(3)
Please, carefully check all of the exterior parts of jack including,
Pump body: no deformation, cracking and impacting on it
Operating handle of pump: no deformation no over space in each plug, otherwise the old
plug shall be replaced by a new one Tooth plate: no deformation & cracking Base: no
deformation &cracking
7. Add oil
If the jack can not be pumped up to its rated height, it is necessary for you to add hydraulic
oil into the oil tank. The hydraulic oil to be used must have a quality of ISO VG22 or
equivalence. Mixing of different fluids is prohibited!