REHM 150 3310, Руководство по эксплуатации

Страница: 35 / 64

Accessories
35
4. Accessories
The equipment listed below can be supplied as accessories. This equipment is
connected to the remote control socket, which is fitted as standard. This
connection is automatically recognised by the control unit. There is no need for
manual switchover. Remote control units remain active for as long as they are
plugged into the power source!
4.1 WIG PLUS 1 foot operated remote control
By means of the WIG PLUS 1 foot remote control, the welding current can be
adapted to the welding job all the time during welding, via a foot pedal. The
current set at the machine is the current set when the pedal is depressed. This
makes it possible to set the maximum desired current, resulting in optimum
resolution in the particular current range!
When the foot-operated remote control is used, the torch control cable is not to
be plugged into the 7-pole socket. The remote control is connected to this socket
and the ignition of the torch is achieved by depressing the foot control. Striking
the arc and switching between two current with the torch button is not possible
when using the foot control.
Attention: The adapter cable Article number (Article No. 3600390, see
chapter 4.5) is required in order to connect a foot or hand operated remote
control to the Tiger machine!
The WIG PLUS 1 foot operated remote control has a selector switch, which has
the following functions:
4.1.1 Switch position; Foot-operated control signal
In this operating mode, the welding current is switched on and off automatically
using the foot pedal and is controlled using the foot. The welding machine
automatically operates in the 2-step mode of operation. The upslope and
downslope times are automatically disabled.
Warning: The operator must make sure that his foot does not switch on the
machine inadvertently. When the foot pedal is actuated, there is a risk of
electric shock from high-voltage!
4.1.2 Switch position; Hand-operated control signal
The welding current is controlled via the foot pedal. This enables that during
stick-electrode welding the welding current can be varied as required. This
possibility is not suitable for TIG welding, as the torch trigger control cable is not
plugged in, therefore the ignition via the torch button cannot take place.
4.2 WIG PLUS 2 Hand remote control
Using the WIG PLUS 2 hand remote control on the machine enables the welding
current to be altered from between 0 % und 100 % of the set value. This remote
control is designed for stick-electrode welding. This remote control is not
designed for use in conjunction with TIG welding, as the torch trigger control
cable is not plugged in, therefore the ignition via the torch button cannot take
place.