│
34
REGULUS SRS6 EP Controller - www.regulus.eu
Special functions
menu 6
6.4.2 Thermostat
menu 6.4.2
Thermostat is used for time- and temperature controlled additional heating.
Settings range: On, Off, Inverted
Temperature values which are set too high can lead to scalding or damage to the system. Scalding
protection must be provided by the customer!
In Energy savings mode, different settings may apply, see e.g. T eco.
6.4.2.1 - TH Set
Target temperature at thermostat sensor 1. Below this temperature, additional heating is switched on, till TH
set + hysteresis is reached.
Settings range: 0-100 °C / Default setting: 50
6.4.2.2 - TH hysteresis
menu 6.4.2.2
Hysteresis of setpoint temperature.
Settings range: -20-+20K / Default setting: 10K
6.4.2.3 - Thermostat sensor 1
menu 6.4.2.3
T set is measured with thermostat sensor 1.
When thermostat sensor 2 is also connected, the relay switches on when T set is undershot at thermostat
Sensor 1, and switches off when T set + hysteresis at thermostat sensor 2 is exceeded.
Settings range: S1-S8, VFS1-2, active storage / Default setting: none
6.4.2.4 - Thermostat sensor 2
menu 6.4.2.4
Optional switch off sensor
When T set + hysteresis is exceeded at the optional thermostat sensor 2, the relay is switched off.
Settings range: S1-S8, VFS1-2, active storage / Default setting: none
Special functions
menu 6
6.4.2.5 - T eco
menu 6.4.2.5
For Energy saving mode
When Energy saving mode is active: During solar charge T eco is used instead of TH set. When the tempera-
ture drops below T eco at thermostat sensor 1, the relay is switched on and heats up to T eco + hysteresis.
Settings range: 0-100 °C / Default setting: 40 °C
6.4.3
-
Storage
menu 6.4.3
For Energy saving mode
Loading this storage activates the Energy saving mode
When this storage is charged by solar, additional heating is only switched on when the temperature is below T
eco.
Settings range: (Storage sensors) / Default setting:
fi
rst storage
Danger
Caution
