Regulus SRS6, Инструкция по установке и эксплуатации

Страница: 12 / 56

│
12
REGULUS SRS6 EP Controller - www.regulus.eu
D - TERMINAL CONNECTION
D 1 - Terminal block wiring
Example: solar system with a storage tank and el. heating rod with an integrated thermostat.
Sensor connection - max. 12V
Caution
Mains voltage
100-240V 50Hz
Danger
D 1 - Terminal block wiring
On the circuit board:
SRS6 EP ver. V4:
VFS1
Grundfos Direct Sensor
VFS2 Grundfos Direct Sensor
CAN1 CAN Bus
CAN2 CAN Bus
S6
VFS2 VFS1 CAN CAN
V1
V2 +
S5 S4 S3 S2 S1
-
PELV
R3I
R3 R2 R1 L N
N
-
Low voltage - sensor connection
Terminal: connection for:
S1 Sensor 1
S2 Sensor 2
S3 Sensor 3
S4 Sensor 4
S5 Sensor 5
V1 Output 0-10V / PWM
Terminal „ – „ is connected with a common
terminal block for S1-S4 sensors and VFS
sensors and also with earth on the mains side.
The power supply of low-energy pumps
with 0-10V / PWM pumps can be connected to
the corresponding relay (V1 -> R1, R2 -> V2),
since the relays are switched on and off with
the signal.
Mains voltage 100 - 240V 50Hz
Terminal: connection for:
R2 Relay 2
R1 Relay 1
R3 Relay 3 (normally open, NO)
R3I Relay 3 (normally closed, NC)
L Mains phase
N Mains neutral
PE protective conductor
(green-yellow)