Regency liberty LRI3E, Инструкция для владельца и по установке

Страница: 35 / 56

LRI3E / HRI3E Direct Vent Gas Insert
|
35
|
35
operating instructions
LIGHTING PROCEDURE
SHUTDOWN PROCEDURE
1. Place ON/OFF switch located on appliance in (I) ON position
2. Simultaneously press the off and large lame buttons on the remote hand held until a short beep conirms
the start sequence has begun. Release both buttons.
3. Continuing beeps conirm the ignition is in process.
4. Once pilot ignition is conirmed, main valve will open and lame will be present.
Note: Once ignition has been established and lame is present the remote control handset will automatically
go into manual mode.
Important : The irst attempt for ignition will last approximately 30 seconds. If there is no lame ignition, the
appliance will stop beeping. To restart the ignition process repeat step 2 of the lighting procedure.
If after 2 attempts the appliance does not light, wait 5 minutes and repeat steps for ignition
1. Press the OFF button on the remote to shut off the appliance.
2. Place ON/OFF switch located on appliance in (O) OFF position.
3. If service is to be performed–you must disconnect power and shut off gas to the unit.
Coding instructions.
Important : The remote control/Receiver for this appliance comes pre-coded for your convenience and does not require to be recoded after changing batteries
in the hand held. As long as there is 120 volt power to the appliance and a 9 volt battery in the remote handset this will operate as normal.
If the remote for some reason ever required to be re-coded as a result of losing its learning code, follow these instructions below:
1. Press and hold the receiver's reset button until you hear two (2) beeps. The irst beep is short. To gain access to the receiver reset button you will need to
use the tool provided. A lashlight may be required to visually see the reset button.
2. Within the subsequent 20 seconds of pressing and holding the reset button, press the small lame icon button on the handset until you hear two additional
short beeps conirming the code is set. If you hear one long beep. This indicates the code learning sequence has failed or the wiring is incorrect. A 9 volt
battery is required in the hand held when coding the remote hand held.
Reset tool
Reset receiver
Reset button location
The receiver requires a tool for reset. The tool is located underneath the glass door. Remove the Vignette
(front faceplate) to access this tool (see instructions in this manual).