34
|
LRI3E / HRI3E Direct Vent Gas Insert
|
34
operating instructions
DO NOT ATTEMPT TO CLEAN THE
GLASS WHILE IT IS HOT.
Note: When the glass is cold and the appliance
is lit, it may cause condensation and fog
the glass. This condensation is normal
and will disappear in a few minutes as
the glass heats up.
DO NOT BURN THE APPLIANCE
WITHOUT THE GLASS FRONT IN
PLACE.
AUTOMATIC CONVECTION
FAN OPERATION
The fan operates automatically to adjust to the
desired speed. The fan will turn on as the stove
comes up to operating temperature. After the unit
has been turned off and the unit cooled to below
a useful heat output range the fan will shut off
automatically.
During the irst few ires, a white ilm
may develop on the glass front as part
of the curing process. The glass should
be cleaned or the ilm will bake on and
become very dificult to remove. Use a
non-abrasive cleaner and NEVER clean
the glass while it is hot.
OPERATING
INSTRUCTIONS
Before operating this appliance, proceed through
the following check list.
1)
Read and understand these Instructions before
operating this appliance.
2)
Check to see that all wiring is correct and en-
closed to prevent possible shock.
3)
Check to ensure there are no gas leaks.
4)
Make sure the glass door is in place. Never oper-
ate the appliance with the door glass removed.
5)
Verify that all venting and the cap is unobstructed.
6)
Verify log /glass crystal placement. If the pilot
cannot be seen when lighting the unit - the logs
/ crystals, or the embers have been incorrectly
positioned.
7)
The unit should never be turned off and on again
without a minimum of a 60 second wait.
8)
When lighting the appliance, the inside of the
glass may fog up. This will burn off after a few
minutes of operation.
DO NOT BURN THE APPLIANCE WITH
THE GLASS DOOR REMOVED.
FIRST FIRE
The irst ire in your stove is part of the paint curing
process. To ensure that the paint is properly cured,
it is recommended that you burn your ireplace for
at least four (4) hours the irst time you use it with
the fan on. When irst operated, the unit will release
an odour caused by the curing of the paint, the
burning off of any oils remaining from manufacturing.
Smoke detectors in the house may go off at this
time. Open a few windows to ventilate the room for
a couple of hours.
The glass panel may require cleaning after the unit
has cooled down.
Содержание liberty LRI3E
