Regency Fireplace Products U39-NG12, Инструкция для владельца и по установке

Страница: 42 / 60

42
|
Regency ® U39-12 ULTIMATE™ Freestanding Gas Stove
operating instructions
Proflame GTMF System Operating Instructions
System Description
The Proflame Remote Control System consists of three elements:
1.
Proflame Transmitter.
2.
Proflame Receiver and a wiring harness to connect the Receiver to the
gas valve, stepper motor and Fan Control Module.
3.
Proflame Fan Control Module (FCM).
Transmitter (Remote Control with LCD Display)
The Proflame Transmitter uses a streamline design with a simple button
layout and informative LCD display (Fig. 1).
The Transmitter is powered by 3 AAA type batteries.
A Mode Key is provided to Index between the features and a Thermostat
Key is used to turn on/off or index through Thermostat functions (Fig. 1 & 2).
The Proflame Remote Control System consists of three elements:
1. Proflame Transmitter.
2. Proflame Receiver and a wiring harness to connect the Receiver to the gas valve, stepper
motor and Fan Control Module.
3. Proflame Fan Control Module (FCM)
The Proflame Transmitter uses a streamline design with a simple button layout and informative
LCD display (Fig. 1).
The Transmitter is powered by 3 AAA type batteries.
A Mode Key is provided to Index between the features and a Thermostat Key is used to turn
on/off or index through Thermostat functions (Fig. 1 & 2).
TRANSMITTER (Remote Control with LCD Display)
SYSTEM DESCRIPTION
4
ENGLISH
Fig. 1: PROFLAME Transmitter.
Blue LCD display
UP/DOWN Arrow Key
ON/OFF Key
THERMOSTAT Key
MODE Key
Low battery alarm
Child safety lock-out
Room
Temperature
Aux ON
Set Point
Temperature/Level/State
Flame ON
Thermostat
OFF/ON/SMART
Fan
Fig. 2: Transmitter LCD display.
Transmission
Figure 2 - Transmitter LCD Display
Figure 1 - Proflame Transmitter
Operating Procedure
Initializing the System for the first time
Install the 4 AA batteries into the receiver battery bay. Note the polarity of the
battery and insert into the battery bay as indicated on the Battery cover (+/-).
Place the 3 position slider switch in the “Remote” position. (fig. 3) Using the
end of a paper clip, or other similar object, insert the end of the paper clip
into the hole marked “PRG” on the Receiver front cover (fig 3). The Receiver
will “beep” three (3) times to indicate that it is ready to synchronize with a
Transmitter. Install the 3 AAA type batteries in the Transmitter battery bay,
located on the base of the Transmitter. With the batteries already installed
in the Transmitter, push the On button. The Receiver will “beep” four times
to indicate the Transmitter's command is accepted and sets to the particular
code of that Transmitter. The system is now initialized.
Temperature indication Display
With the system in the “OFF” position, press the Thermostat Key and the Mode
Key at the same time. Look at the LCD screen on the Transmitter to verify
that a C or F is visible to the right of the Room Temperature display. (Fig. 3)
Figure 3 - Remote Control Display in Fahrenheit and Celsius
Figure 4 - Remote Control Display