Regency Fireplace Products Panorama PG36 Series, Инструкция для владельца и по установке

Страница: 29 / 48

Regency ® PG36 Gas Fireplace
|
29
operating instructions
During the first few fires, a white film may
develop on the glass front as part of the
curing process. The glass should be cleaned
or the film will bake on and become very
difficult to remove. Use a non-abrasive
cleaner and NEVER clean the glass while
it is hot.
First Fire
The FIRST FIRE in your heater is part of the
paint curing process. To ensure that the paint is
properly cured, it is recommended that you burn
your fireplace for at least four (4) hours the first
time you use it with the fan on.
When first operated, the unit will release an odour
caused by the curing of the paint and the burning
off of any oils remaining from manufacturing. Smoke
detectors in the house may go off at this time. Open
a few windows to ventilate the room for a couple of
hours. The glass may require cleaning.
NOTE: The main burner will always start on
"HIGH" and resume it's last setting
after 20 seconds of operation.
NOTE:
When the glass is cold and
the appliance is lit, it may cause
condensation and fog the glass.
This condensation is normal and will
disappear in a few minutes as the glass
heats up.
DO NOT ATTEMPT TO CLEAN THE GLASS
WHILE IT IS STILL
HOT !
DO NOT BURN THE APPLIANCE WITHOUT
THE GLASS FRONT IN PLACE.
Lighting Instructions
1. Plug the power cord into a power outlet.
2. Press and release the ON/OFF button once to
start the unit.
3. After approximately 3 seconds the spark ignition
system will spark for 40 seconds to light the
main burner.
4. If the main burner does not light, reset the unit.
Resetting the Unit
1. Open the bottom louver of the unit.
2. Press and release the reset button, located on
the unit's control panel once.
3. Wait for approximately 3 seconds and the pilot
sparks can be heard and seen. It would take 2
to 3 seconds for the flame to be lit.
NOTE:
A period of 30 seconds must pass
before another reset is attempted.
Shutdown Instructions
1. Press the ON/OFF button once.
2. Turn off all electric power to the appliance if
service is to be performed.
Operating Instructions
Before operating this appliance, proceed through
the following check list.
1. Read and understand these Instructions before
operating this appliance.
2. Check to see that all wiring is correct and
enclosed to prevent possible shock.
3. Check to ensure there are no gas leaks.
4. Make sure the three pieces of door glass
are properly positioned. Never operate the
appliance with any of the glass removed or
with the door open.
5. Verify that all flueing and the cap is unobstructed.
6. Verify log placement.
Remote Control
Use the Regency ® Remote Control Kit approved
for this unit. Use of other systems may void your
warranty.
The remote control kit comes with a hand held
transmitter and a wall mounting plate.
1. Choose a convenient location to mount the hand
held transmitter, protection from extreme heat
is very important.
The remote can also be used as a wall thermostat.